Computherm KonvekPRO, Руководство по эксплуатации

Страница: 9 / 28

- 9 -
2.6. Place KonvekPRO onto the screws prepared on
the wall and, with a cautious vertical motion, fix
it in place. In case of correct installation Konvek-
PRO is seated stably against the wall surface.
2.7. Connect the cable leading to the thermostat
to KonvekPRO . Put a thin two wire cable into
the thermostat connector located in the lower
part of KonvekPRO then tighten the fastening
screws with a small watchmaker’s screwdriver,
reaching through the holes on its top.
Several KonvekPRO can be combined and
connected to a single thermostat but in this
case you should ensure correct polarity: in
this case make sure that the right-hand side
cable of each thermostat connector located
on KonvekPRO s to be combined is connected
to the connector on the right side of the other
KonvekPRO s while left cables are connected
only to left connectors.
2.8. Install the thermostat (which is compatible only