Computherm KonvekPRO, Руководство по эксплуатации

Страница: 19 / 28

- 19 -
5.1. After you have completed installation, set the
connected digital thermostat temporarily to a
temperature considerable lower than that of
the room to prevent it from switching the gas
heater on.
5.2. Turn the temperature regulating knob of the gas
heater to minimum setting (pilot flame).
5.3. With the orange LED thereon KonvekPRO indi-
cates that it works and has started to heat the
probe incorporated therein. When the LED goes
out, the probe reached the temperature set on
KonvekPRO . After a few minutes the LED is on
then goes out again to keep the temperature
at this value. This target temperature (switch-
ing threshold value) is set to approx. 30 °C
by the manufacturer and this is suitable in the
overwhelming majority of cases. But if not, with
a screwdriver you can increase (clockwise) or
decrease (anticlockwise) this threshold value in