CommScope RUCKUS ICX 7550, Руководство по установке оборудования

Страница: 64 / 141

2. Change the chassis name by using the chassis name command.
device(config)# chassis name SJ001
sj_device1(config)# end
sj_device1# write memory
The chassis name command does not change the device CLI prompt. Instead, the command assigns an administrative ID to the device.
Setting the Date and Time
Use the following command to set the current date and time for the device.
device# clock set
hh:mm:ss Current Time
device# clock set 10:05:45
mm-dd-yy/yyyy Current Date
device# clock set 10:05:45 12-01-16
NOTE
After a power cycle, the date and time settings are not retained because the device does not have an RTC battery.
Establishing a Connection to the Out-of-Band Management
Port
The Gigabit Ethernet management port (RJ-45) on the RUCKUS ICX 7550 non-port side panel provides an out-of-band network connection to the
device.
After you assign an IP address, you can access the RUCKUS ICX 7550 from anywhere in the attached network using Telnet, a web browser, or other
network management tools. To prevent unauthorized access, RUCKUS recommends that the management port only be connected to a secure
private network.
To manage the RUCKUS ICX 7550 through its management port, connect the port to the management Ethernet network using Category 5 or better
cable.
Management of the RUCKUS ICX 7550 is described in detail in the RUCKUS FastIron Management Configuration Guide.
Getting In-Band Access
You can access the management agent in the device from anywhere within the attached network using Telnet or other network management
software. However, you must first configure the device with a valid IP address, subnet mask, and default gateway. If you have trouble establishing a
link to the management agent, check to see if you have a valid network connection. Then verify that you entered the correct IP address. Also, be
sure the port through which you are connecting to the device has not been disabled. If it has not been disabled, then check the network cabling
that runs between your remote location and the device.
Verifying the Correct Operation
Check the LEDs to verify operation of functional parts. The following commands can be useful to establish an operational baseline for the device.
Refer to the RUCKUS FastIron Command Reference for more information on these commands.
• show chassis
Initial Setup and Verification
Setting the Date and Time
RUCKUS ICX 7550 Switch Hardware Installation Guide
64 Part Number: 53-1005648-04