Commend G3-IAX Series, Руководство по эксплуатации продукта

Страница: 27 / 42

G8-IAX / G3-IAX PABX mode
3.0/0616 27
Dialling timeout (“block dialling”)
The dialling of a call number in PABX mode is carried out after a short timeout by default (whether the
channel is dialled manually or direct outward dialling is used – “block dialling”).

Press the button
F
at the Intercom station to skip this timeout (the dialling is carried out immedi-
ately).

By means of a configuration via CCT 800, it is possible to adapt this timeout to individual require-
ments (
see page 30 ).
Dynamic call transfer
By means of the Intercom function “executive-secretary transfer chain” it is possible to configure a
form of a “bundle function” for outgoing phone calls. This means, a “bundle” of channels are assigned
to an IAX trunk, even across multiple cards. Therefore, the channels are allocated dynamically:

Several channels have to be configured as subscribers of a call transfer chain.

If a channel of the call transfer chain is called that is already busy, the call will be automatically trans-
ferred to the next idle channel of the chain.

In case the last channel of the transfer chain is busy too, it is possible to start the transfer of the call
along the configured transfer chain again (configuration of a timeout via CCT 800 required,
see
page 31 ).
Schematic illustration of a dynamic call transfer chain
End conversation

End the conversation by pressing the button “#” at the VoIP phone or by pressing the button
X
at
the Intercom station.
NOTE: Availability of dynamic call transfers
Dynamic call transfers are available for phone calls built up by dialling the channel manually or by
direct outward dialling.
NOTES: End conversation
 When an outgoing conversation is ended, also the (call) connection between Intercom system and
VoIP system will be disconnected (contrary to incoming calls,
see page 22 ).
 In order that a phone call, initiated by dialling the channel manually, can be ended by pressing the
button “#” at the telephone, the function
”After dialling at telephone – outgoing phone call” has to
be configured.
Gx-IAX-4 Gx-IAX-4
Channel
101
101 busy 102 busy 103 busy 121 busy
104 busy
124 busy Waiting time e.g. 5 sec
122 busy 123 busy
Channel
102
Channel
103
Channel
104
Channel
121
Channel
122
Channel
123
Channel
124