COMAC ULTRA 120 B-G, Руководство по эксплуатации и обслуживанию

Страница: 38 / 72

38
MACHINE
PREP
ARA
TION
DETERGENT SOLUTION (VERSION WITHOUT CDS)
After filling the solution tank with clean water add the liquid
detergent to the tank in the concentration and manner indicated on
the detergent manufacturer's label. To prevent the formation of an
excessive amount of foam that could damage the vacuum motor,
use the minimum percentage of detergent required.
ATTENTION: protective gloves should always be worn when
handling detergents or acidic or alkaline solutions, to avoid
serious injury to the hands.
ATTENTION: always use detergents whose manufacturer's
label indicates their suitability for scrubbing machines. Do not
use acid or alkaline products or solvents without this
indication.
ATTENTION: always use low-foam detergent. To avoid the
production of foam, put a minimum quantity of antifoam liquid
in the recovery tank before starting to clean. Do not use pure
acids.
FILLING THE DETERGENT CANISTER (VERSIONS WITH CDS)
After filling the solution tank with clean water, proceed as follows:
1. Bring the machine to the area designated for refilling the solution
tank.
2. Make sure the machine is in a safe condition (read “ MACHINE
SAFETY ”).
ATTENTION:
protective gloves should always be worn when
handling detergents or acidic or alkaline solutions, to avoid
serious injury to the hands.
3. Remove the detergent canister cap ( Fig.1 ).
4. Fill the canister with the required detergent.
ATTENTION: always use detergents whose manufacturer's
label indicates their suitability for scrubbing machines. Do not
use acid or alkaline products or solvents without this
indication.
ATTENTION: the dosing system is suitable for frequent
maintenance cleaning. Acid or alkaline maintenance
detergent tank be used with pH values between 4 and 10 and
that do not contain: oxidising agents, chlorine or bromine,
formaldehyde, mineral solvents. The detergents used must be
suitable for use with scrubbing machines. Wash the circuit
with water after use if the system is not used daily. The system
can be excluded. In case of sporadic use of detergents with
pH between 1-3 or 11-14, use the floor scrubbing machine in
the traditional way by adding the detergent in the clean water
tank and excluding the dosing circuit.
ATTENTION: always use low-foam detergent. To avoid the
production of foam, put a minimum quantity of antifoam liquid
in the recovery tank before starting to clean. Do not use pure
acids.
5. Make sure you tighten the cap properly to avoid any leakage of
liquid while working ( Fig.2 ).
1 2