COMAC ULTRA 120 B-G, Руководство по эксплуатации и обслуживанию

Страница: 50 / 72

50
MAINTENANCE
RECOMMENDED MAINTENANCE OPERATIONS
Note:
(1) In any event check the battery charge level when working.
DRAINING THE RECOVERY TANK
Proceed as follows to empty the recovery tank:
1. Select the i-drive program “transport” by rotating the knob to
position “A” as shown in (
Fig.1
).
ATTENTION: by rotating the i-drive selector to the transport
program, the brush head and squeegee will move to their idle
positions (raised above the floor).
2. Take the machine to the maintenance area.
ATTENTION: the place designated for this operation must
comply with current environmental protection regulations.
3. Make sure the machine is in a safe condition (read “ MACHINE
SAFETY ”).
ATTENTION: users are advised to always wear protective
gloves, to avoid the risk of serious injury to hands.
4. Release the recovery tank drainage tube (2) (at the back of the
machine) from the retainers ( Fig.2 ).
5. Bend the end of the drainage tube, so as to create a choke and
prevent the content from coming out ( Fig.3 ), put the tube on the
discharge surface and gradually release the tube.
ATTENTION: the place designated for this operation must
comply with current environmental protection regulations.
6. Repeat the operations in reverse order to reassemble all the
parts.
3 1 2
1 1 2 1
TYPE OF MAINTENANCE
AT THE END OF THE WORK DAIL
Y
WEEKL
Y
BEFORE A
LONG
PERIOD OF NON- USE TRANSPORT
RECHARGING THE BATTERIES (1) X
DRAINING THE RECOVERY TANK X X X
CLEANING THE SQUEEGEE UNIT X X X
CLEANING THE BRUSHES X X
CLEANING THE VACUUM MOTOR FILTER X X
DRAINING THE SOLUTION TANK X X X
CLEANING THE SOLUTION TANK X X
CLEANING THE WATER SYSTEM FILTER X X
CLEANING THE VACUUM TUBE X X
CLEANING THE BRUSH HEAD SPLASH GUARD RUBBERS X X
CLEANING THE DETERGENT CANISTER (VERSIONS WITH CDS) X
CLEANING THE WATER SYSTEM X
CLEANING THE WATER SYSTEM (VERSION WITH CDS) X