COMAC ULTRA 120 B-G, Руководство по эксплуатации и обслуживанию

Страница: 31 / 72

31
18. Close the fuel tap (13) by moving the lever (14) in the direction
shown by the arrow ( Fig.18 ).
19. Grip the handle (12) and lower the seat mounting plate to the
working position ( Fig.19 ).
ATTENTION: secure the device according to the directives in
force in the country of use, so that it cannot slide or tip over.
20. If the machine is an LPG version, remove the cylinder from
its support (read the “REMOVING THE LPG CYLINDER”
paragraph).
TYPE OF BATTERY TO BE USED (B VERSIONS)
TYPE OF BATTERY TO BE USED (G VERSIONS)
TYPE OF LPG CYLINDER TO BE USED (G VERSIONS)
The batteries must meet the requirements laid out in the norms: DIN/EN 60254-2 and IEC 254-2-2 (L range).
For good working performance, we suggest the use of a 36V 720 Ah/C
5
acid battery box.
The batteries must meet the requirements laid out in the norms: DIN EN 50272-3.
For good working performance, we suggest the use of a 12V 45A battery.
The most suitable cylinder is the one with Ø 30cm and height 60cm.
MAINTENANCE AND DISPOSAL OF THE BATTERIES (B-G VERSIONS)
MAINTENANCE AND DISPOSAL OF THE ENDOTHERMIC ENGINE (G VERSIONS)
MAINTENANCE AND DISPOSAL OF THE LPG CYLINDER (G VERSIONS)
For battery maintenance and recharging, respect the instructions provided by the battery manufacturer.
When the batteries reach the end of their working life, they must be disconnected by expert, trained personnel then removed from the battery
compartment with the aid of suitable lifting devices.
ATTENTION: dead batteries are classified as dangerous waste and as such must be delivered to an authorised body for disposal.
For the maintenance of the endothermic engine, respect the instructions provided by the engine manufacturer (read the Use and Maintenance
Manual of the endothermic engine supplied with the machine).
ATTENTION: when disposing of the endothermic engine, it is compulsory to respect the instructions provided by the engine
manufacturer.
For the maintenance of the LPG cylinder, respect the instructions provided by the cylinder manufacturer.
ATTENTION:
when disposing of the LPG cylinder, it is compulsory to respect the instructions provided by the cylinder manufacturer.
MACHINE SAFETY
To ensure that work is carried out in the best safety conditions with
battery versions, proceed as follows:
1. Make sure the solution tank is empty. If this is not the case,
empty it (read " DRAINING THE SOLUTION TANK ").
2. Make sure the recovery tank is empty. If this is not the case,
empty it (read " DRAINING THE RECOVERY TANK ").
3. Shift the direction lever (1) to “idle”, moving it in the direction
shown by the arrow ( Fig.1 ).
4. Engage the parking brake by moving the parking brake lever (2)
(at the side of the operator seat) in the direction shown by the
arrow ( Fig.2 ).
ATTENTION: the indicator light (3) relating to the engaged
parking brake will be activated on the control panel ( Fig.3 ).
5. Bring the main switch (4) to "0", turning the key (5) a quarter turn
to the left ( Fig.4 ). Remove the key from the instrument panel.
19
18
13
14
17