Columbus Instruments Exer 3, Инструкция по эксплуатации

Страница: 62 / 78

60
6.7 AutoCal Speed
This is used to perform an automatic belt speed and odometer distance calibration. You must have the
Speed Sensor to successfully perform this function.

Press the ODOMETER RESET button to select the option. The screen will display:

Press the MODE button to toggle the treadmill belt mode from STOP to RUN. The treadmill belt
will move at half-speed and a 15-minute timer will begin to count down:
The automatic calibration procedure can be stopped at any time by pressing the MODE button to toggle
the treadmill belt mode back to STOP.
Now the Speed Sensor needs to be installed on the Treadmill and connected to the Treadmill Controller.

Remove the thumbnuts and remove the treadmill cover and lid.

Place the Speed Sensor over one of the threaded studs and secure with a thumbnut. Be sure the wheel
is aligned parallel to the running belt (the body of the sensor may not).
After the count-down time expires, the Treadmill Controller will check for a speed output from the Speed
Sensor. If detected, then the calibration procedure will continue, else the screen will display:
Verify the connection to the treadmill. If all appears correct, try cycling the AC power and start the
calibration again. Else, contact Columbus Instruments for help. Once a speed output has been detected, the
low speed calibration will automatically begin.
Run to Start...
Stop to Cancel..
Waiting: 14:59s
Speed Sensor
Not Detected...