Columbus Instruments Exer 3, Инструкция по эксплуатации

Страница: 44 / 78

42
5.2 Incline Controller Setup

Turn the “RATE” knob clockwise, all of the way to the end-stop.

Set the mode toggle switch to “STOP”.

Now, switch ON the Incline Controller. The power switch is above the AC power receptacle on the
rear panel. The front panel display should report the set position of the “INCLINE” knob (upper left),
the actual incline of the apparatus (upper right), the maximum incline rate (lower left) and the mode of
“STOP”:

Adjust the “INCLINE” knob so the set position matches the apparatus’ actual incline to ensure it won’t
move when enabled.

Now set the mode toggle switch to “RUN”.

Adjust the “INCLINE” knob to “ 0.0° ”.
-0.5° 0.0°
1.9°/s Stop
0.0° 0.0°
1.9°/s Run