41
SECTION 5
PERFORMING A PC-CONTROLLED EXPERIMENT
The Treadmill Software provides more control over the treadmill than the Treadmill Controller alone. The
belt speed and acceleration can be varied continuosly as well as the stimulus switched on and off
throughout the entire experiment session. Data from the treadmill system are collected and logged at
intervals into an experiment data file.
5.0
Treadmill Controller Setup
Attention!
Use the following procedure to prevent the application of an undesirable
treadmill belt speed or high intensity shock upon the application of AC power.
Disable the stimulus for all lanes by setting toggle switches toward the rear of the treadmill.
Switch ON the Treadmill Controller. The power switch is above the AC power receptacle on the rear
panel.
Set the “SPEED” to zero “
0.0
” then press and release the MODE button to set the treadmill belt
RUN (the mode indicator should be a progress bar that grows from left to right):
5.1
Treadmill Stimulus Detection Setup
Switch ON the Treadmill Stimulus Detection. The power switch is above the AC power receptacle on
the rear panel. The first option of the menu should be dispayed:
If the power was already ON, then press and release the RESET button to quit the current operation and
return to the top of the menu
S 0.0 ▄ D 0.0
A 1.0/1 E102.3
Mode: ■ Manual
O PC
Содержание Exer 3
