Columbus Instruments Exer 3, Инструкция по эксплуатации

Страница: 32 / 78

30
3.4 Connecting the Components (continued)

Connect the 15-pin shock cable between the “Shocker” port of the Treadmill Controller and the
15-pin D-Sub jack on the Exer 3/6 Treadmill.

Use the fasteners, built-in to the cables ends, to secure the cable to the ports.

Connect the 6-circuit motor cable between the “Motor” port of the Treadmill Controller and the
6-position Molex Mini-Fit Jr jack on the Exer 3/6 Treadmill. Be sure the locking lever snaps down to
secure the cable to the ports.

Connect the AC power cord to the rear panel AC power receptacle of the Treadmill Controller and
insert the other end into an appropriate AC outlet.
DO NOT switch on the Treadmill Controller at this time!
Refer to SECTION 4.0 – Stand-Alone General Exercising without the Computer
or
SECTION 5.0 – Performing a PC-controlled Experiment
for further instructions.