25
570
571.1
571.2
B) Pump Fed Machines
With your clean, sanitized hands, install the feeding
elbow into the cylinder feed hole. Next slide the elbow
connecting tube into the pump cover hole.
Holding the connecting tube inside the pump cover hole,
slide the feeding elbow away from the pump. This will
seat the tube and elbow to prevent the tube from sliding
out when under pressure.
Fill each mix tank with fresh liquid mix. Each mix tank
has a maximum capacity of 10 quarts. The minimum
recommended mix quantity is 3 quarts.
With the mix tanks filled with liquid mix and the
elbows connected to the pumps, you can now prime
the cylinders. To prime the cylinders, press the
“Select” button on the touch pad, selecting the
“Beater” only mode. Allow the machine to run for
approximately one minute the press the “Stop”
button.
Carefully push the plastic bleed plunger, which
extends from the front of the feeding elbow. This will
allow the air to escape from the cylinder.
When all of the pressure is released, press the
“Select” button and switch to the “Beater” only mode
for one minute. After one minute, press the “Stop”
button and carefully push the plastic bleed plunger,
which extends from the front of the feeding elbow.
Repeat this process until a steady stream of mix only
is flowing from the bleed hole on the feeding elbow.
You may now start the freezing process by pressing
the “Select” button (#571.2) and selecting the
Automatic mode.
The initial freeze time is approximately 4-7 minutes.
Do not dispense product until the machine has cycled
off. The draw rate, portion size, and mix viscosity
will determine the final regulator tube setting.
Adjust for your specific application.
