21
Install the pump body assembly into the rear hub inside
of each mix storage tank. Slide the drive shaft into the
rear hub and rotate the pump until the hook stud
engages the pin on the rear hub. At this point, you
must ensure that the drive shaft is engaged into the rear
drive coupling by turning the drive gear until it
completely engages.
The freezer is now completely assembled and must be
sanitized prior to adding fresh mix and operating.
Install the mix pump drive shaft seal into the rear of
the mix pump body.
Lightly
lubricate the inside of the
shaft seal then install the drive shaft into the pump seal
engaging it into the drive gear.
Assemble the plastic suction tube (#271) by installing
the oring (#1126) into the groove and lightly lubricate.
Next lightly lubricate the base (flat part) of the relief
valve (#245) and install into the well of the mix pump
cover (#202).
Install the spring (#206) onto the relief valve in the
pump well. Install the suction tube with lubricated
oring into the pump cover well engaging the spring
into the suction tube recess. To lock the suction tube
onto the pump cover, rotate, the tube until the
adjustment lever is pointed away from the pump cover
(6 o’clock position).
You are now ready to install the pump cover with
suction tube onto the pump body assembly, which is
installed on the rear pump hub in the mix storage tank.
To install the cover, first ensure that the oring (#1178)
is installed into the pump body (#39). Next, affix the
pump cover onto the pump body using the two metal
retaining knobs (#8).
