Cole Parmer MB-200-40, Инструкция по эксплуатации

Страница: 41 / 60

Page 38 of 60
10.1.4 PASSCODES
To enable the security features in the balance it is necessary to set
passcodes. There are 2 passcodes called Operator Passcode and
Supervisor Passcode. The Operator Passcode allows an authorized user to
operate the basic weighing functions of the analyzer but will not allow access
to the Supervisor Menus if the Supervisor Passcode has been set.
To change or disable a Passcode it will be necessary to enter the current
passcode.
Press [Setup/Enter] when “PASSCODES” is displayed to enter this section.
OPERATOR
Enter the current passcode (OLD) first then enter a new
passcode if desired. A passcode set to zero will disable
the security feature and allow unlimited access.
SUPERVISOR First enter the current passcode (OLD) and then enter a
new passcode if desired. A passcode set to zero will
disable the security feature and allow unlimited access.
10.1.4.1
FORGOTTEN PASSCODES
Keep a record of the passcode to ensure you can access this section again.
If however you have forgotten your passcode you can still gain access by
entering a universal code.
If you have forgotten the current passcode a code of “15” will always allow
you to enter the Supervisor area.
Using the Supervisor menus go to the PASSCODE section and reset the
operator or Supervisor passcode using the “15” code as the old number
when requested.