16
Page 16 of 24 M7819 Issue 4.2
9.2.2. Remove any loose food from the inner and outer containers by pre-scraping.
9.2.3. Fill the outer container with clean , potable water up to the 3 litre (middle)
level line embossed mark on the rear wall.
9.2.4. Set the toggle switch to LO and verify the POWER ON LED is illuminated.
9.2.5. When the POWER ON LED goes off again (i.e., water is at selected
temperature), set the toggle switch to the off position.
9.2.6. Using the pull-action tap, half fill the inner container with heated water from
the outer container.
9.2.7. Using a field mess spoon, add two spoonfuls of hand dishwashing compound
to both containers and stir vigorously to produce suds.
Note:
In paragraph 9.2.8 retain the wash water if the cover and / or the
main case are to be cleaned.
9.2.8. Clean the pull-action tap by draining off one canteen cupful of the outer
container wash water and discard.
9.2.9. Using a scrubbing brush or a scouring pad, scrub both containers until they
are free of any persistent food residue and / or discolouration.
9.2.10. Discard the water contents of both containers.
9.2.11. Half fill the outer container with clean potable water and rinse off all traces of
hand dishwashing compound.
9.2.12. Flush the pull action tap by draining of the outer container water contents into
a receptacle of suitable capacity. Discard drained water.
9.2.13. Rinse the inner container in clean, potable water to remove all traces of hand
dishwashing compound.
9.2.14. Allow both containers to air dry.
Note: To clean the cover, perform the procedure in sub paragraph. 5.2.16
9.2.15. Return the HW & R to normal service.
Cleaning the Cover.
9.2.2. Remove any loose food from the inner and outer containers by pre-scraping.
9.2.3. Fill the outer container with clean , potable water up to the 3 litre (middle) level line
embossed mark on the rear wall.
9.2.4. Set the toggle switch to LO and verify the POWER ON LED is illuminated.
9.2.5. When the POWER ON LED goes off again (i.e., water is at selected temperature), set
the toggle switch to the off position.
9.2.6. Using the pull-action tap, half fill the inner container with heated water from the
outer container.
9.2.7. Using a field mess spoon, add two spoonfuls of hand dishwashing compound
to both containers and stir vigorously to produce suds.
Note: In paragraph 9.2.8 retain the wash water if the cover and / or the main
case are to be cleaned.
9.2.8. Clean the pull-action tap by draining off one canteen cupful of the outer container
wash water and discard.
9.2.9. Using a scrubbing brush or a scouring pad, scrub both containers until they are free
of any persistent food residue and / or discolouration.
9.2.10. Discard the water contents of both containers.
9.2.11. Half fill the outer container with clean potable water and rinse off all traces of
hand dishwashing compound.
9.2.12. Flush the pull action tap by draining of the outer container water contents into
a receptacle of suitable capacity. Discard drained water.
9.2.13. Rinse the inner container in clean, potable water to remove all traces of hand
dishwashing compound.
9.2.14. Allow both containers to air dry.
Note: To clean the cover, perform the procedure in sub paragraph. 9.2.19
9.2.15. Return the HW & R to normal service.
Содержание Electrothermal RAK30 HW & R
Страница 22: ...12 NOTES 22...
Страница 23: ...23 12 NOTES...
