11. Display panel
The display panel at the rear of the
CF 1200 Spot
is used to display and set
functions
function information and various parameters.
Altering the
coemar
factory settings may vary the functioning of the projector, cau-
sing it to not respond to external DMX 512 signal. Please read and familiarise your-
self with the following information very carefully before altering any selections.
reset
This function carries out a reset in the case, however unlikely, that one or more
motors lose their reference points.
1) Press the
menu
button
2) Press the
+
or
-
buttons till
rESE
(for reset) is displayed.
3) Press the
enter
button to confirm your selection. The projector will proceed to
perform a reset.
rate
This function provides information on the speed or rate of
DMX 512
signal being
received by the
CF 1200 Spot
.
1) Press the
menu
button
2) Press the
+
or
-
buttons till
rAtE
(for rate/speed) is displayed.
3) Press the
enter
button to confirm; the display will show a numerical value which
is the rate/speed of the
DMX 512
signal being received.
hour
This function provides information on the number of hours of operation of the
CF
1200 Spot
.
1) Press the
menu
button
2) Press the
+
or
-
buttons till
HoUr
(for hour) is displayed.
3) Press the
enter
button to confirm your selection. The display will show a value
which is the length of time which the fixture has been in operation.
life
This function provides information on the number of hours of operation of the lamp
in the unit.
1) Press the
menu
button.
2) Press the
+
or
-
buttons until
LIFE
(for lamp life) is displayed.
3) Press the
enter
button to confirm your selection. The display will show a numeri-
cal value which is the length of time in hours that the lamp has been operated
since the counter was last reset.
resetting the lamp life counter
The lamp life counter needs to be reset to zero at every lamp change to provide
accurate information on lamp life.
1) Turn off the projector.
2) Whilst holding down the
+
and
-
buttons, turn power back on to the projector.
3) Press the
menu
button.
function display
menu
+
-
enter
function display
menu
+
-
enter
function display
menu
+
-
enter
function display
menu
+
-
enter
