Cobra CS9, Инструкция по установке и эксплуатации

Страница: 9 / 20

7
The following commissioning checks must be
carried out before the appliance is handed over for
use, to ensure that the unit operates correctly and
the operator(s) understand the correct operating
procedure.
1. Before leaving the new installation;
a. Check the following functions in accordance
with the operating instructions specified in
the ‘Operation’ section of this manual.

Light the Main Burners.

Check the Low Fire burner operation.

Check the High Fire burner operation.

Check the Racking System operation.
b. Ensure that the operator has been instructed
in the areas of correct lighting, operation,
and shutdown procedure for the appliance.
2. This manual must be kept by the owner for future
reference, and a record of Date of Purchase,
Date of Installation and Serial Number of Unit
recorded and kept with this manual. (These
details can be found on the Rating Plate
attached to the R/H side panel (refer to the ‘Gas
Connection’ section).
NOTE:
If for some reason it is not possible to get the unit to
operate correctly, shut off the gas supply and
contact the supplier of this unit.
3. Fit the gas regulator supplied, into the gas supply
line as close to the appliance as possible.
NOTE:

The burner operating pressure is to be measured
at the manifold test point with two burners
operating at the 'High Flame' setting.

NAT, LPG & Butane Only - The operating pressure
is ex-factory set and is not to be adjusted, apart
from when converting between gasses, if
required.

TOWN GAS Only - The burner operating pressure
is to be adjusted using the adjustable gas
regulator supplied.

Refer to the ‘Gas Conversion and Specifications’
section of this manual for further details.
The regulator connections are
1
/
2
" BSP female.
The connection to the appliance is
1
/
2
" BSP male.
(Refer to the the ‘Specifications’ section for the
gas supply location dimensions).
NOTE:
A Manual Isolation Valve must be fitted to the
individual appliance supply line.
4. Correctly locate the appliance into its final
operating position and using a spirit level, adjust
the legs so that the unit is level and at the
correct height.
5. Connect the gas supply to the appliance. A
suitable jointing compound which resists the
breakdown action of LPG must be used on
every gas line connection, unless compression
fittings are used.
6. Check all gas connections for leakages using
soapy water or other gas detecting equipment.
7. Check that the gas operating pressure is as
shown in ‘Specifications’ section.
NOTE:
The operating pressure to be measured at the
manifold test point and with both burners operating
at the ‘High Flame’ setting.
8. Verify that the operating pressure remains
correct.
D
O NOT USE A NAKED FLAME TO CHECK FOR GAS LEAKAGES
.