6
5. Lower the Salamander onto the mounting
bracket.
6. Tighten the black spacers
securely and adjust the
levelling screws / bolts to
ensure that the unit is level.
NOTE:
ALL GAS FITTING MUST ONLY BE CARRIED OUT BY A
QUALIFIED SERVICE PERSON.
1. Cobra salamanders do not require an electrical
connection, as they function totally on the gas
supply only.
2. It is essential that the gas supply is correct for the
salamander to be installed and that adequate
supply pressure and volume are available. The
following checks should therefore be made
before installation:-
a.
Gas Type
the appliance has been supplied
for, is shown on a coloured stickers located
above the gas connection and next to the
rating plate. Check that this is correct for the
gas supply the appliance is being installed
for. The gas conversion procedure is detailed
in this manual.
b.
Supply Pressure
required for this appliance is
shown in the ‘Specifications’ section of this
manual. Check the gas supply to ensure
adequate supply pressure exists.
c.
Input Rate
of this appliance is stated on the
Rating Plate fitted to the R/H side panel and
in the 'Specifications' section of this manual.
The input rate should be checked against
the available supply line capacity.
Particular
note should be taken if the salamander is
being added to an existing installation.
NOTE:
It is important that adequately sized piping runs
directly to the connection joint on the appliance
with as few tees and elbows as possible to give
maximum supply volume.
NOTE:
Only non-combustible materials can be used in
close proximity to this appliance.
We recommend allowing a clearance of 100 mm on
either side of the appliance to allow access to
the side panels for servicing purposes.
** Using the wall mounting accessories provided
with this appliance.
*** Top clearances can be reduced where local fire
protection system is provided, if allowed by the
local regulations.
1. Fix the wall mounting bracket to the wall with six
screws, in such a position that the top of the
bracket is level and at least 945mm (38”) above
any surface beneath the unit. This will ensure
that the bottom of the Salamander is at least
600mm (24”) above any surface.
2. Fit the two black plastic spacers to the top rear
corners of the unit. Leave them unscrewed by
approximately 5mm.
3. Fit the two adjusting screws / bolts into the
nutserts at the bottom rear corners of the unit.
These should protrude approximately 30mm from
the rear of the Salamander.
4. Lift the Salamander onto the wall bracket, lining
up the black plastic spacers on the salamander
with the mounting notches in the bracket.
~ 5 mm
~30 mm
LH / RH Side
100 mm
25 mm (*)
Rear
50 mm
30 mm
Top Clearance to:
- Extraction Hood
200 mm
- Grease Arresting Filter (**)
400 mm
- Ceiling (***)
750 mm
Содержание CS9
Страница 1: ...Gas Salamander Model CS9 I N S T A L LA T I ON A N D OP E R A T I ON M A N U A L 242353 1 ...
Страница 6: ...4 CS9 Gas Salamander ...
Страница 20: ......