5. Drain engine transmission oil by removing drain screw using a 13mm- hex
wrench. (item 2 in the figure below).
6. Remove kick-starter cover using a 5mm hex key. (item 3 six places)
7. Remove clutch and basket.
8. Unscrew water elbow fitting. (Figure 40)
Figure 40
8. Remove ignition cover using a 4mm hex key (four places)
9. Remove belt retainer screw using a 4mm hex key. (Figure 41 - item 1)
10. Remove belt retainer, water pump belt and water pump fan pulley.
11. Remove bearing retainer screw using a 3mm hex key. (Figure 41 – item 2)
Figure 41
12. Heat engine case around area of impeller lightly with a small Burnsmatic propane
torch. Using a 3/8” diameter x 8” long steel rod, tap impeller assembly out of
engine as shown in figure 42.
Figure 42
CAUTION:
Too much heat can be detrimental to the engine cases.
13. The shaft assembly is serviceable. Use a 1/8” hex key to remove impeller
retainer screw. Remove impeller, seal and both bearings. Check shaft for wear in
59
Содержание 2005 King
Страница 1: ......
Страница 46: ...Figure 25 Figure 26 45...