the area of the seal. If there is any sign of wear (like a groove) replace the shaft.
Figure 43
14. Reinstall new bearings, seal (open side toward impeller) and impeller. Clean all
threads and use green (wicking / bearing retainer) thread locker.
15. Using a liberal amount of grease on the outside seal, bearings and inside of
case, reinstall bearing assembly by using a 0.500” ID by 1.000” OD steel tube 2”
long and tap on end of tube per figure 44.
Figure 44
16. Re-assemble in same order of disassembly.
CAUTION:
Clean all threads and use green (wicking / bearing retainer) thread locker on the belt
retainer screw.
NOTE:
Apply Ultra black Hi-Temp RTV silicon gasket maker to the threads of the water
pump 90° elbow fitting before assembly.
NOTE:
Refill the coolant system with
Liquid Performance
Propylene Glycol based Mini
Coolant / Antifreeze.
CAUTION:
Do not mix Propylene Glycol based coolant / antifreeze solutions with Ethylene
Glycol based coolant / antifreeze solutions.
60
Содержание 2005 King
Страница 1: ......
Страница 46: ...Figure 25 Figure 26 45...