9711IMA-70
Installation
3-25
3.9.3.
Remove stow Straps
Remove the stow straps from the pedestal and repackage them in the Antenna Stow Kit.
Provide this kit to the responsible person aboard the ship so it can be stored for future use.
3.9.4.
ADE Final Checks
Remove all tools, parts and installation debris from inside the radome.
Remove all tools, parts and installation debris from the area around the outside of the radome.
3.10.
Installing the Below Decks Equipment
Connect this equipment as shown in the System Block Diagram. Install the equipment in a standard 19 inch
equipment rack or other suitable location. Optional slide rails are available for the Sea Tel MXP.
3.10.1.
General Cautions & Warnings
CAUTION - Electrical Shock Potentials exist on the Gyro Compass output
lines. Assure that the Gyro Compass output is turned OFF when handling and
connecting wiring to the MXP.
CAUTION - Allow only an authorized dealer to install or service the Sea Tel
System components. Unauthorized installation or service can be dangerous and
may invalidate the warranty.
3.10.2.
Connecting the BDE AC Power Cables
Connect the AC Power cables that supply power to the Below Decks Equipment (MXP, Satellite Modem,
phone, fax, computer and all other equipment) to an outlet strip fed from a suitably rated breaker or UPS.
3.10.3.
Media Xchange Point™ (MXP) Connections
3.10.3.1.
Ships AC Mains
Connect the power cord from the rear panel of the MXP to AC voltage power source (UPS
power recommended).
3.10.3.2.
J1 Modem RX
Connect this RXIF Output to the satellite modem RX Input using an appropriate coaxial cable.
3.10.3.3.
J2 RJ - Antenna RX
Connect this RXIF Input from the antenna to this port on the rear panel of the MXP using
coaxial cable provided
3.10.3.4.
J3 A/B & J4 A/B - Ethernet 4 Port 10/100 switch
Ethernet connections to computer, satellite modem LAN devices as desired.
3.10.3.5.
J5 SFP Fiber Interface
SFP Gigabit Ethernet connection.
3.10.3.6.
J6 Mini-USB Computer M&C Connection
Mini-USB Antenna M&C connection, if desired.
3.10.3.7.
J7 USB Host
Not connected - -Future development.
3.10.3.8.
J8 Console
Antenna M&C Serial connections.
EAR Controlled - ECCN EAR99
Содержание SEA TEL 9711IMA-70
