COBHAM SEA TEL 9711IMA-70, Руководство по установке

Страница: 32 / 178

Installation 9711IMA-70
3-12
1. Place the radome base frame
on temporary support blocks,
or jack stands, at least 22
inches high.
2. Loosely assemble the eight
legs, eight interior braces and
four outer braces from the
underside of the radome base
frame to the
second hole
from the top in the bottom
end of the legs using the
hardware provided.
3. Assure that the legs and
braces are correctly
assembled.
4. Apply Loctite to the bolt
threads and tighten all the
hardware to specified torque.
5. Remove the support blocks, or
jacks, and set the base frame
down on the flat, even,
assembly surface to align the
feet. Apply Loctite and
tighten all the hardware to
specified torque.
6. Install the Base Hatch and
clamp the latches from the
under-side.
3.7.3. Marine Air Conditioner
If your order included a marine air conditioner:
1. If your order included a marine
air conditioner, open its’ crate.
2. Install it onto the center of the
base pan, properly oriented with
the cutouts in the fiberglass
base pan.
3. Apply Loctite to and Install the
mounting bolts provided with
the air conditioner.
4. Tighten to torque spec.
3.7.4. Assembling the Lower Radome Panels
Refer to the Radome Assembly drawing for your system and the procedure below. It is best to have at
least TWO people sub-assembling the radome, one working from the inside and the other outside. Sub-
assemble the sections of the radome on a clean, flat location that is free of rocks and debris (i.e.
concrete) to assure good horizontal alignment of the panels.
If there are a sufficient number of people available to each hold a panel while an additional person
loosely installs a bolt/nut high, mid and low on each flange, the bottom half of the radome can be
assembled very quickly. With three bolts loosely holding each flange the radome will then stand as a
loose bowl and the extra 5 people can leave. Loosely install the rest of the hardware in each flange.
EAR Controlled - ECCN EAR99