Setup with the web interface for PC
4-10
Chapter 4: Setup and operation
98-144390-C
4.1.5
Navigation
In this section you can set Heading, Position, Manual pointing and Fixed installation.
•
Heading:
GNSS or manual setting.
•
Position
: You can enter a fixed position if the position provided by the internal GNSS
module is not sufficiently good or you do not want to wait for a GPS fix.
•
Manual pointing:
This turns off the motors in the antenna and you must make a
manual pointing using the hand crank.
•
Fixed installation:
Selected this if the EXPLORER 3075GX is set up as a fixed
installation, i.e. when the EXPLORER 3075GX will not move over time and where access
to the EXPLORER 3075GX is not intended and/or difficult.
Do as follows:
1. Select
SETTINGS > Navigation
from the left navigation pane.
2. Set the Heading,
Position, Manual pointing and Fixed installation
:
Figure 4-7: Web interface: SETTINGS > Navigation
Item
Description
Position mode GNSS
- GNSS module is used for current position (default).
Manual -
enter values from other position source. (Accuracy should
be better than 50 m.)
Manual
pointing
This turns off the motors in the antenna and you must make a manual
pointing using the hand crank.
Fixed
installation
The EXPLORER 3075GX automatically allows the GX modem to enter
the network after reboot in case of a temporary power loss. No user
action is required.
Fixed installation
is allowed after the EXPLORER
3075GX has been pointed to the satellite.
Table 4-6: Web interface: SERVICE > Navigation
