CoachComm Tempest NG Sideline, Руководство пользователя

Страница: 18 / 64

Tempest NG User Manual v1.2013 13
Components
WIM 8(RD) Screens
Menu Structure
Splash Screen
— This screen is displayed for a few seconds at power up of a WIM 8 or WIM 8(RD).
Default Operating Screen
— This screen is displayed during normal operation of the WIM 8(RD). The display shows all eight
communication lines (1) and the status of both +24volt sides of those lines (2). A solid triangle indicates appropriate intercom
power is present on a particular side of an intercom channel. If the user has a 4 channel NG system, there will be no triangles
showing under lines 5 through 8. To enter the “TEST MODE”, the user has to depress and hold the buttons (there are two) under
the display directly below the words “Test” (3) for five seconds. The WIM 8(RD) has a test disable switch on the rear that makes
it impossible for the unit to go into test mode. If that switch is in the “Disable” position, the display will alert the user and revert
back to the Default Operating Screen. If test is successfully initiated, the user will see a status screen for approximately 1 minute,
then the fault screen will display.
Dry Pair Testing Fault Screen
— This screen displays the faults found during the dry pair testing. If no faults are detected the
screen will only show the header information with no detail line items listed below. The local pairs (1) are compared to the
remote pairs (2) in a matrix. In Screen A, the system is showing that Pair 1 on the local unit corresponds to Pair 3 on the remote
unit. Screen A also shows that Pair 2 locally is connected to Pair 4 on the remote side of the system. It also shows that lines 3 and
4 locally are connect to 1 and 2 on the remote end. If there are more than four lines of errors, the soft buttons will change to read
“NEXT” and “PREV” as is appropriate. The user can use the buttons under PREV and NEXT to scroll through the results.