CoachComm Tempest NG Sideline, Руководство пользователя

Страница: 56 / 64

Tempest NG User Manual v1.2013 51
Game Day Setup
4. Power up Base A and observe the LQ at the corresponding BeltPacks. The LQ should read “99” at start-up.
a. If they do not read “99”, power OFF the BaseStation and be sure no other 900 MHz devices are operating near your
system. Antennas on the opposite sideline should not impact your start-up LQ.
b. If they do read “99”, continue on to the next step.
5. Power up Base B and observe the LQ on the FIRST set of BeltPacks that correspond to Base A.
a. If the LQ reads “99”, confirm the LQ for the second set of BeltPacks for Base B is also “99.” If so, your NG900 BaseSta -
tions are configured and ready to use.
b. If the LQ reads anything other than “99”, follow the next step to reset the radio on Base B.
6. If LQ does not read “99” at start-up, reset the radio on Base B within the “Tech Menu”:
a. On the front of Base B, Press MENU.
b. Press “1-BaseStation Settings”.
c. Scroll to “6-Tech Menu” and press ENT.
d. Press ENT thru Warning Message.
e. Scroll to “3-Diagnostics”.
f. Scroll to “2-Reset Radio” and the “Reset Radio” screen
will display the LQ values for each of the BeltPacks on
Base B.
7. Press ENT to reset the radio for Base B. After a few
seconds the LQ values on the screen will begin re-initializing. This process should only take 4-5 seconds.
a. If the LQ values for Base B are “99”, confirm the LQ for Base A BeltPacks are also “99.” If so, your NG900 system is
ready for use.
b. If the LQ values indicate anything other than “99” on Base B, press ENT to reset the radio again for Base B. Follow step
7 until the LQ for Base B reads “99” for all of your belts.
IMPORTANT: While in the “Reset Radio” menu, the audio across
that BaseStation will be negatively affected; do NOT monitor LQ
values from this menu during game operation or walk-testing!