11
eVenue Tempo
H a r d w a r e O p e r a t i o n
Hardware Operation
Tempo Control Unit
The Tempo Control Unit controls all audio outputs to ePods connected as part of the eVenue Tempo system. An overview of the
Control Unit’s hardware is provided in Figure 4 on page 5
,
and operation of this product is detailed in procedures on the following
pages.
Connections and Controls
Audio Sources
eVenue Tempo Software:
The eVenue Tempo Software is the user interface and main audio source for the eVenue Tempo system.
Its installation and operation is detailed beginning on page 19 of this manual.
Mic:
To operate a microphone, plug its 3-pin XLR connector into the
Mic
input on the I/O connection panel. Then, adjust the volume
with the e
Venue Tempo Remote or Volume switch
. The eVenue Tempo system has no phantom power; therefore, always use a
dynamic microphone.
Tempest FX (if applicable):
The Voice Announce feature broadcasts one’s voice through the entire eVenue Tempo system using
your existing Tempest FX system. To operate this feature, open the eVenue Tempo Software and connect a headset to the appropriate
BeltPack. Hold down the STAGE button (see Figure 16) on the BeltPack through the entirety of speaking. See the Hardware
Installation section of this manual on page 9 or more information about connecting your Tempest FX system to eVenue Tempo.
Figure 14: I/O Connection Panel Mic Connection
Figure 15: eVemue Tempo’s Control Unit connections for the Tempest FX
BaseStation.
→
Figure 16: Sample Stage Button on BeltPack
