CMT ORANGE TOOLS CMT3, Инструкция по эксплуатации

Страница: 11 / 55

8
ENGLISH
Replace or turn the blade over, inserting it with the fl at
surface facing the retaining bolt head (Fig.3).
Attention - For correct machine operation it is essential
that the blade is inserted in the right direction, as shown
in Fig. 6.
Loosen the retaining screws
B
(Fig.2). until the blade and
blade support are securely fastened to roller
A
.
Repeat the operation for the other blade.
Attention - After having completed this operation, ensure
that the blade and blade support are securely fastened to
the roller, if not serious accidents may occur.
8.4 REPLACEMENT OF THE BLADE SUPPORT
(Fig.2)
Carefully clean the blade and the blade support.
Repeat the operations performed for blade replacement,
but when sliding out the blade also remove the blade
support. Then proceed to replacement operations
(Fig.2).
Attention
- Before inserting the blade support on the roller,
make sure that grub screws
A
, fi tted on the blade support
(Fig.3), are tightened so that they do not protrude from the
blade support surface; this is to avoid that the blade is not
positioned parallel to the working surface.
In order to check the parallel position of the blade, place a
ruler on the mobile working surface (Fig.2) and adjust the
surface, using knob
A
(Fig.4), until the blade just touches
the ruler (Fig.2).
If the blade is not perfectly level, it can be adjusted by
tightening grub screws
A (Fig.3), thereby rendering the
blade perfectly parallel to the work surface.
For ulterior verifi cation, pass the blade over a wooden
surface and check the parallel position.
8.5 REPLACEMENT OF THE BELT
The eventual replacement of the belt can be carried
out by loosening the retaining screws and removing the
guard
I (Fig.1).
Avoid using screwdrivers or sharp levers for this operation,
as they may damage the new belt.
Attention!
This operation should only be performed by an
authorized service center.