Clifford Concept 650MkII, Руководство по установке

Страница: 32 / 60

www.directed.com
30
multiple event total recall
This will report the last eight system triggers.
1. Press and hold of the PlainView 2 Valet switch.
2. While still holding , arm and disarm the system, then release the button.
3. The LED will start to flash to indicate the most recent trigger and proceed down to
the eighth trigger. If fewer than eight triggers are stored in memory, the LED will
flash continuously until the system is armed/disarmed or the ignition is turned on.
For more information, please refer to the Table of Zones section of this guide.
table of zones
When using the diagnostic functions, use the Table of Zones to see which input has
triggered the system. It is also helpful in deciding which input to use when connecting
optional sensors and switches.
N NO OTTEE:: The Warning Zone response does not report on the LED.
system features programming
This system has many features that can be programmed to accommodate the user's
personal preferences and make system installation easier. They are listed in two pro-
gramming grids on the following pages. Many features have default settings that have
been programmed at the factory and are indicated in bold type.
The User Selectable Features grid allows the user and installer to change operational
features through the PlainView 2 Valet. The Installer Selectable Features grid allows
the installer to change input/output functions of the system to integrate with the vehi-
cle’s specific characteristics.
LED Flashes Trigger type Input description
1 Data Optional Proximity Sensor
2 Data Optional Omnisensor
3 Mux 1 Optional Tilt/motion Sensor
4 Instant Door Switch Input
5 Instant Boot Pin Input
6 Instant Bonnet or Normally Closed Input
7 Instant Ignition Input
8 Mux 2 Optional Glass Tamper Sensor or Ultrasonic
Sensor
9 N/A BlackJax* Activation
10 N/A Alarm power reset