Cleveland APD, Инструкция по установке, эксплуатации и обслуживанию, Страница: 7 / 26

PLUGS
AUTO VENT DRAIN PLUG FILL LEVEL PLUG
(MUST BE OPENED BEFORE OPERATING)
COMMISSIONING
Prior to mixer start-up, complete the following:
Check the lubricant and be sure that the gear unit is filled with the •
proper oil type, to the proper level, as determined by the mounting
position (this info will also be indicated on the mixer's ID tag).
Check to make sure all breather vents are open
•
Check to make sure the oil expansion chamber (if one was •
provided) is installed correctly.
All mounting hardware is torqued to the appropriate value (not
•
torqueing the bolts can create an unbalance).
If a mechanical seal is required, the seal was installed/set according
•
to the manufacturer's requirements, the shipping clips are removed,
the seal has lubrication (if it's not a dry running seal), the seal has
been pressure tested.
The motor is wired to run in the correct direction with the
•
appropriate voltage and needed amperage to run the motor.
The shaft and impeller assemblies are properly installed. If a steady
•
bearing was supplied, the SB was laser aligned with the reducer
output after the reducer was mounted on the tank. The shaft should
be straight to .001" per inch.
The mixer has been test bumped before entering into normal
•
operation.
LONG TERM STORAGE
Store the reducer in its designed mounting position in accordance with •
the specified oil-fill level in a clean, dry environment. Avoid temperature
fluctuations within the range of 32°F - 104°F and relative humidity
conditions in excess of 60%.
Keep shaft sections level and flat, preferably crated to avoid warping
•
and scoring the metal. Coat the shaft, impellers, hubs, keys, couplings
(any metal parts) etc. with grease to prevent rust and corrosion.
(continued on next page)
PAGE 5
RXT & APD AGITATOR MANUAL_09-17-15_JN