Cleveland APD, Инструкция по установке, эксплуатации и обслуживанию, Страница: 5 / 26

USA
Standard
GRADE 5 GRADE 8 316 STAINLESS STEEL
THREAD
SIZE
FT LB DRY
FT LB
LUBED
FT LB DRY
FT LB
LUBED
FT LB DRY
FT LB
LUBED
1/4-20 8 6.3 12 9 6 5
5/16-18 17 13 24 18 11 10
3/8-16 30 23 45 35 20 17
7/16-14 50 35 70 50 33 28
1/2-13 75 55 110 80 45 38
9/16-12 110 80 150 110 59 50
5/8-11 150 110 210 160 96 82
3/4-10 260 200 380 280 131 111
7/8-9 430 320 600 450 202 172
1-8 640 480 910 680 299 254
FASTENERS
Tighten all fasteners to the values shown unless specifically instructed to •
do otherwise.
Lubricate all fasteners at assembly with grease, oil or anti-seize material •
If fasteners cannot be lubricated, use dry torque spec provided on chart. •
Loose hardware can cause catastrophic damage. It is very important to •
check all fasteners at scheduled maintenance intervals.
If your process is corrosive or sanitary check the wetted hardware to •
make sure it is the correct grade before assembly.
Always use washers and lock washers if they were provided. •
Calculated tightening torques are based on conventional 60°F, clean and dry or lubricated
(as indicated above) thread. Standard fasteners will be supplied with a split lock washer.
Cleveland Mixer recommends a minimum of grade 5 (ASTM A449) for all hardware to 1-8 and
grade SAE 8 for larger sizes.
RXT & APD AGITATOR MANUAL_09-17-15_JN
PAGE 3