Cleveland APD, Инструкция по установке, эксплуатации и обслуживанию, Страница: 16 / 26

STEP 1 - (detail page 11) Use the
mixer mounting flange with a
shaft catcher (or your own
bracing) to suspend the weight
of the mixer shaft. Assemble the
shaft coupling to the mixer
shaft(make sure to torque and
use thread locker on the cap
plate bolts). If there's a
mechanical seal, lip seal or
packing gland be sure these
are in place (not yet locked
down) under the shaft coupling
before assembling the
coupling.
STEP 2 - The gear reducer,
motor, pedestal and stub
shaft will typically be
shipped preassembled from
the factory (if your is not, you
will need to assemble these
parts before completing this
step) in step 2, use the
appropriate lifting
techniques to lift and lower
the drive end of the mixer to
mate with the mixer shaft or
mixer shaft coupling. Use the
fasteners supplied to make
this connection before
resting the weight of the
drive on the bracing or shaft
catcher.
fasten coupling hardware •
remove shaft catcher •
fasten flange hardware •
torque the fasteners •
install seal •
TAPER BORE COUPLING
Assemble to top
of mixer shaft
MIXER DRIVE ASSEMBLED TO TANK FLANGE
RXT & APD AGITATOR MANUAL_09-17-15_JN
PAGE 13
If you're mixer requires a
mechanical seal, you'll
need to set it in place on
the shaft below the shaft
coupling before the shaft
coupling is fastened in
place. Slide the
mechanical seal on the
shaft, carefully so it sits
about the shaft catcher.
You will not need to fasten
the seal to the flange or
lock it to the shaft until the
rest of the mixer assembly is
assembled.