Cleveland APD, Инструкция по установке, эксплуатации и обслуживанию, Страница: 13 / 26

RXT & APD AGITATOR MANUAL_09-17-15_JN
PAGE 11
ASSEMBLING THE SHAFT FIXING ELEMENT
For RXT, APD and SDM models with a hollow output shaft, a fixing
element kit will be supplied with your mixer. This kit will include a cover
plate w/ hardware, a cap plate with a lock washer and bolt, a
plastic bore cap, shaft key and a snap ring (not supplied with some
units).
You mixer will have one of the following configurations:
1. A straight shaft, a shaft with a single diameter from end to end. This
is the shaft that will require a snap ring installed in the groove towards
the top of the shaft quill. This snap ring will prevent the shaft from
sliding up through the shaft quill from the thrust of the mixer.
2. A shouldered shaft, a shaft with a step that will sit just below the
lower slow speed seal of the reducer. This shoulder fills the role of the
snap ring used on the straight shaft.
3. A stub shaft, this shaft might be shouldered or straight. It's a short
shaft with a coupling a longer shaft will connect to.
Shouldered Shaft Straight Shaft
Assembly:
1. Slide shaft up into the hollow
shaft quill in the reducer from
the bottom of the reducer.
Keep the key slots lined up.
2. Insert shaft key thru the shaft
quill at the top of the reducer.
so it aligns with the top of the
shaft
3. If you have a shaft that
requires a snap ring, insert the
ring into the snap ring groove
inside the shaft quill. The snap
ring will sit at the top of the
shaft.
4. Insert the cap plate at the
top of the quill, use the lock
washer and bolt supplied to
lock the assembly together.
Torque the shaft bolt.
5. Install the cover cap and
cover plate.
Cover Plate
Cap Plate Bolt w/
Lock washer
Cap Plate
Snap Ring
Shaft Key
Mixer Shaft
Hollow Quill