Clementi FAMILY Series, Руководство пользователя

Страница: 43 / 59

84 85
ENG
The installation of the oven must only be performed by a qualified technician,
aware of the contents of this manual. Follow the instructions carefully before in­
stalling the oven. Any change to the oven could be dangerous and cause damage
to people or property.
This oven has been designed for outdoor use, and it has to be placed away from
any flammable material. It is important that there are no obstructions and that
there is a free space around the oven of at least 50 centimeters. It is important that
the ventilation slots of the oven are not obstructed.
Place your oven on a flat even surface away from any combustible materials.
Ideally a stone or concrete floor is preferred. Consult local building and fire regula­
tions for the recommended safe distance from buildings, partitions and coverings
such as pergolas and roofs. Additional parts maybe required.
Check for wind direction to ensure the wind is not blowing directly into your oven
as this may cause the gas burners to go out.
When installing the Family oven, size the support surface, and its legs, so that it
can adequately support the weight of the oven without causing risks to the users
(FAMILY 60X60 wood version = Kg100, gas version = Kg 120 - FAMILY 80X60 wood
version = Kg120, gas version = Kg140 - FAMILY 100x80 wood version = Kg235, gas
version = Kg245), also carefully evaluate the materials and dimensions of the sup­
ports used.
The support surface has to be strictly made of non-flammable material. Provide a
suitable opening of at least 40cm by 40cm in the central part of the support for
the ventilation of the base of the oven and of all its components, and for any main­
tenance or adjustment of the burner.
POSITIONING YOUR OVEN
USING YOUR CLEMENTI GAS FIRED
OVEN
GAS FIRED O
V
EN
ENG
The screw used for the adjustment of the fuel air mixture is positioned under the
base of the oven and it is necessary to allow the possibility of adjusting its opening
or closing for a greater or lesser entry of oxygen to the burner. This opening will
also be used to disassemble and clean the nozzle.
The connection of the appliance to the pipeline or to the gas bottle must be car­
ried out as prescribed by the UNI-CIG 7129 and 7131 Standards. Make sure that it is
regulated for the type of gas which will be used. Use low pressure regulators with
fixed setting 30/37 mbar compliant with UNI-EN 16129 Standards.
Connection with pipe: use only pipes conforming to UNI-CIG 7140 Standards or
UNI EN 14800 Standards. At the ends of the rubber pipes, it is necessary to fix the
appropriate hose clamps in compliance with the UNI-CIG 7141 Standards. The pi­
pes must not be subjected to tensile stresses or torsion and must not have exces­
sively tight curves or bottlenecks. The flexible piping of the gas must not exceed
1.5 meters.
ATTENTION: Recommended fuel LPG gas (G30 / G31) - 28/37 mbar; consumption
max 1.15 Kg / h.
The liquid gas bottle must be placed away from any intense heat source. In case
the gas bottle is placed in a special cylinder cabinet, the pipes must be accessible
for inspection along their entire length.
The connection to the gas system must be made in such a way as not to cause
stress of any kind to the appliance.
Use only pipes compliant with the UNi-CIG 9891 standard and sealing gaskets
compliant with the UNI-CIG 9264 standard.
GAS FIRED O
V
EN