13
CLEARSPAN
™
END WALL FRAMING KITS
Revision date: 10.04.16
End Frame and Panel with Overhead Door: Cut Door Openings
Diagram above shows the end frame and end panel as seen
from inside a similar shelter
.
Wrap this portion
of the end panel
around and
secure it to the
door frame using
Tek screws and
washers. See
Step 1 in the next
procedure.
Door Jamb
12"-16"
12"-16"
Example Door Opening
(Can be used on any size door)
Header
Door
Jamb
Ground Level
Remove this shaded portion
of the end panel material to
create and opening for the
overhead door.
Step 3 Cut
Horizontal Conduit
used to stretch the
end panel during
installation.
END PANEL
END PANEL
12"-16"
Horizontal
Conduit
Follow these steps to cut a door opening in the installed
and stretched end panel:
1. Consult diagram below and mark a 12" to 16" border on
end panel
within the door frame
of end frame.
2. Using the diagram and marks as guides, remove end
panel material. See shaded area in diagram below.
3. To allow end panel to wrap around door framing, make
a diagonal cut from corner of door frame to corner of
end panel where material was removed. See circles in
diagram below.
4. Continue with Secure End Panel to Frame Instructions
that follow.
Ground Level
