CLEAN BURN CB-200-CTB, Руководство оператора

Страница: 79 / 148

Coil Tube Boiler Operator's Manual: Models CB-200-CTB, CB-350-CTB, and CB-500-CTB
7-1
SECTION 7: RESETTING THE OIL PRIMARY CONTROL
Figure 7A - Oil Primary Control for CB-200-CTB
ATTENTION: It is very
important that the "F" and
"T" terminals of the Oil
Primary Control are wired
exactly as shown in Figure 7A.
NEVER connect jumper wires
to these terminals or severe
damage may occur to the Oil
Primary Control.
Understanding the Oil Primary Control (CB-200-CTB)
The oil primary control will go into safety lockout and
shut the burner off when it detects flame-out during
burner operation. The following procedure explains
what should be done when this occurs.
It is very important that you follow these
instructions precisely when resetting the safety
on the primary control and restarting the burner.
Resetting the Oil Primary Control
(CB-525-S2 Burner)
DANGER! DO NOT push the reset
button more than once! DO NOT push
the reset button if oil mist is present in the
combustion chamber or when the combustion
chamber is hot! DO NOT operate your boiler if
excess oil, oil vapor or fumes have accumulated in or
near your boiler. As with any oil burning
appliance, improper operation may result in a
fire or explosion hazard.
1. Refer to Figure 7A.
2. Check the combustion chamber for fuel mist by
shining a flashlight through the observation port. If
you see fog (fuel mist) in the chamber, DO NOT
push the reset button.
3. If the combustion chamber is hot, allow the boiler
to cool for at least 30 minutes. DO NOT push the
reset button.
4. When you are sure all mist has been cleared from
the chamber and the combustion chamber is cool,
depress the red button on the primary control for a
minimum of three (3) seconds, then release. Reset
the control ONCE ONLY.
5. If the burner will not restart, call your Clean Burn
dealer immediately.
RESET BUTTON
THERMOSTAT WIRES
I88787−D
CAD CELL WIRES