CLEAN BURN CB-200-CTB, Руководство оператора

Страница: 31 / 148

Coil Tube Boiler Operator's Manual: Models CB-200-CTB, CB-350-CTB, and CB-500-CTB
3-7
Dual-Stacked Boiler Assembly
Assembling the Dual-Stacked Boiler (continued)
7. Refer to Figures 3D and 3E. Assemble the adaptor bracket using the 1" x 3/8" bolts provided.
NOTE: The adaptor bracket is installed between the two boilers; it is fastened to the underside of the
"top" boiler unit.
8. If you have not already done so, remove the pre-assembled hardware from the top of the "bottom"
boiler. You will use this hardware to fasten the adaptor bracket.
9. Use a forklift to carefully lift the "top" boiler unit from underneath (see safety warning at the beginning
of this procedure).
10. Attach the adaptor bracket to the bottom of the boiler using the 1" x 3/8" carriage bolts provided.
DO NOT completely tighten the bolts until the two units are assembled together.
NOTE: The notches on the adaptor bracket are designed to fit around standard forklift forks.
11. After the bracket has been attached to the underside of the "top" boiler unit, move the "top" unit
into position over the "bottom" unit.
12. Carefully lower the "top" boiler down onto the "bottom" boiler, watching for alignment of the
bracket holes and the holes in the top of the boiler below.
13. Install the hardware through the lower set of holes in the adaptor bracket into the top of the
"bottom" boiler while checking for proper alignment of the two units. Ensure that ALL hardware
is securely tightened.
NOTE: When stacking a CB-200-CTB on top of a CB-350-CTB use an additional set of side channels
turned 180 degrees to help distribute the load around the fork lift notches. This will require lifting the "top"
boiler unit from the front rather than the side. Install the front channel into the adaptor bracket after the "top"
unit is set on the "bottom" unit.
Figure 3E - Dual-Stacked Boiler Adaptor Bracket
I88465-A