CLEAN BURN CB-200-CTB, Руководство оператора, Страница: 58 / 148

Coil Tube Boiler Operator's Manual: Models CB-200-CTB, CB-350-CTB, and CB-500-CTB
4-20
Figure 4I - Installation of "Class A" Stack Through Roof/Ceiling (Single Boiler)
Installing the Interior Stack
CAUTION: Single wall stack components may be used only for those portions of the stack
which are located inside your building and away from any fire/burn hazards.
1. The stack can be installed from either side of the smoke hood breach. Install the 8" smoke cap
onto the unused smoke hood breach ring assembly.
2. Install a piece of the single-wall 24-gauge galvanized stack (minimum 18" in length) onto the
smoke hood breach.
8 INCH MINIMUM
EQUIVALENT
"DEKTITE" OR
3 FEET
A STAINLESS STEEL LINER
10 FT MINIMUM VERTICAL
STACK HEIGHT OR EQUIVALENT
DRAFT SYSTEM TO MAINTAIN
−.02 W.C. DRAFT OVER FIRE
10 FEET
GALVANIZED
STRUCTURE WITHIN 10 FEET OF IT
AND AT LEAST 3 FEET HIGHER THAN
ANY RIDGE, PARAPET WALL OR ROOF
THE LAST STACK SECTION SHALL
EXTEND AT LEAST 3 FEET ABOVE
THE HIGHEST POINT. AT WHICH IT
COMES IN CONTACT WITH THE ROOF.
ALL FUEL,STACK WITH A
FREE FLOW OF TH STACK GASES
NON−RESTRICTIVE TYPE TO ALLOW
DRAFT
S S E L
E R O M
I88681−C
BAROMETRIC
MIN. 24 GAUGE
SINGLE WALL STACK
"CLASS A" STACK THROUGH CEILING
"CLASS A" KIT FOR INSTALLING
FLASHING
ROOF
WATERTIGHT
DOUBLE WALL INSULATED
"CLASS A" UL 103HT STACK
"CLASS A" STACK CAP
DAMPER
DRAFT
INDUCER