Claas DOMINATOR 130, Руководство оператора

Страница: 188 / 390

188 00 0293 210 2 - BA DOMINATOR 150/140/130 - 12/09
10 Fieldwork settings
10.6 Crop receptacle / straw receptacle
67086
83409
10.6.4 Bolting down the free-swinging knives
– Observe the general warnings at the beginning of
the "Fieldwork settings" chapter.
Bolt on free-swinging knives for grain:
– Two free-swinging knives (grain) must be bolted to
each mounting plate (H) as shown in figure.
– Mount hex. bolts (1) from the outside to the inside,
facing the machine centre (M).
Tightening torque:
Bolts with Dacromet coating
M 10 - 10.9 = 55 Nm
Observe decal on the cutting cylinder!
– Install the straw guide plate.
33
28806
Danger!
Risk of injury from sharp knives.
– Always wear gloves to avoid injuries
when removing and installing the knives.
– Arrest the cutting cylinder so it will not
rotate.
Danger!
Use of unauthorised spare parts.
Death or severe injuries, machine damage.
– Use genuine CLAAS spare parts.
Note!
Uneconomic use of machine.
Machine damage.
– The knives must not jam, but must move
freely.
– Operate the cutting cylinder only with a
complete set of knives in each case.
34
28775
M
4
2
4
2
1
5
3
H
3
Designation
1 Hex. bolt
ISO 4014 - M 10 x 55 -10.9
2 Bushing D 30 x 10
3 Free-swinging knife (grain)
4 Bushing D 30 x 11
5 Self-locking nut
ISO 7042 VM 10 -10
H Mounting plate
M Machine centre