Citrix NetScaler SDX 11500, Руководство пользователя

Страница: 73 / 253

© 1999-2017 Citrix Systems, Inc. All rights reserved. p.73 https://docs.citrix.com
Setting up SNMP Alerts on the LOM by Using the NetScaler Shell
To customize your filter and policy settings, see the IPMI Specification 2.0 rev. 1.1 documentation.
The latest IPMI specifications are available from the IPMI section of the Intel website:
http://www.intel.com/content/www/us/en/servers/ipmi/ipmi-specifications.html
Usually, customization in the SNMP Network Management Software is the preferred method, because it can be done one
time at a central location. Therefore, the settings below send all events for all sensors to the SNMP network management
software. These are very low traffic events and therefore should not result in any significant network usage.
To set up SNMP filters
The following commands set up SNMP to allow all events:
ipmitool raw 4 0x12 0x6 0x10 0x80 1 1 0 0xff 0xff 0xff 0xff 0xff 0xff 0xff 0 0xff 0 0 0xff 0 0 0xff 0
To set up a policy list
The following command creates a policy list for all sensors and events:
ipmitool raw 4 0x12 9 0x10 0x18 0x11 0x81
To setting up the destination address for SNMP events
The following command sets up a destination IP address for an SNMP event:
ipmitool lan alert set 1 1 ipaddr <x.x.x.x>
Where, <x.x.x.x> is the IP address to which the SNMP event should be sent.
To specify an SNMP community string name
At the prompt, type:
ipmitool lan set 1 snmp <community string>