Citrix NetScaler SDX 11500, Руководство пользователя

Страница: 157 / 253

© 1999-2017 Citrix Systems, Inc. All rights reserved. p.157 https://docs.citrix.com
Configuring a Channel from the Management Service
May 11, 2015
You can configure a channel manually, or you can use Link Aggregation Control Protocol (LACP). You cannot apply LACP to
a manually configured channel, nor can you manually configure a channel created by LACP. You configure a channel from the
Management Service and select the channel at the time of provisioning a NetScaler instance or later at the time of
modifying a NetScaler instance.
To configure a channel from the Management Service
1. On the Configuration tab, navigate to System > Channels.
2. In the details pane, click Add.
3. In the Add Channel dialog box, set the following parameters:
Channel ID— ID for the LA channel to be created. Specify an LA channel in LA/x notation, where x can range from 1
to a number equal to one-half the number of interfaces. Cannot be changed after the LA channel is created.
Type— Type of channel. Possible values:
Static— configured only on the data interfaces.
Active-Active— configured only on the management interfaces 0/x.
Active-Passive— configured only on the management interfaces 0/x.
LACP— configured on data interfaces as well as the management interfaces 0/x.
Throughput (Applies only to a static channel and LACP)— Low threshold value for the throughput of the LA channel,
in Mbps. In an HA configuration, failover is triggered if the LA channel has HA MON enabled and the throughput is
below the specified threshold.
Bandwidth High (Applies only to a static channel and LACP)— High threshold value for the bandwidth usage of the LA
channel, in Mbps. The appliance generates an SNMP trap message when the bandwidth usage of the LA channel is
equal to or greater than the specified high threshold value.
Bandwidth Normal (Applies only to a static channel and LACP)— Normal threshold value for the bandwidth usage of
the LA channel, in Mbps. When the bandwidth usage of the LA channel becomes equal to or less than the specified
normal threshold after exceeding the high threshold, the NetScaler appliance generates an SNMP trap message to
indicate that bandwidth usage has returned to normal.
4. On the Interfaces tab, add the interfaces that you want to include in this channel.
5. On the Settings tab, set the following parameters:
Channel State (Applies only to a static channel)— Enable or disable the LA channel.
LACP Time (Applies only to LACP)— Time after which a link is not aggregated if the link does not receive an LACPDU.
The value must match on all the ports participating in link aggregation on the SDX appliance and the partner node.
HA Monitoring— In a High Availability (HA) configuration, monitor the channel for failure events. Failure of any LA
channel that has HA MON enabled triggers HA failover.
Tag All— Add a four-byte 802.1q tag to every packet sent on this channel. The ON setting applies tags for all VLANs
that are bound to this channel. OFF applies the tag for all VLANs other than the native VLAN.
Alias Name— Alias name for the LA channel. Used only to enhance readability. To perform any operations, you have to
specify the LA channel ID.
6. Click Create, and then click Close.