Cisco UCS C3160, Инструкция по установке и обслуживанию

Страница: 34 / 106

2-12
Cisco UCS C3160 Rack Server Installation and Service Guide
OL-32062-01
Chapter 2 Installing the Server
Initial Server Setup
Step 4
Open the Cisco IMC Configuration Utility:
a. Press and hold the front panel power button for four seconds to boot the server.
b.
During bootup, press F8 when prompted to open the Cisco IMC Configuration Utility.
This utility has two windows that you can switch between by pressing F1 or F2.
Step 5
Continue with Cisco IMC Configuration Utility Setup, page 2-13 .
Remote Connection Procedure
Step 1
Attach a power cord to each power supply in your server, and then attach each power cord to a grounded
AC power outlet. See the
Power Specifications, page A-2 for power specifications.
Wait for approximately two minutes to let the server boot in standby power during the first bootup.
You can verify system power status by looking at the system Power Status LED on the front panel (see
Figure 1-1 ). The system is in standby power mode when the LED is amber.
Step 2 Plug your management Ethernet cable into the system I/O controller (SIOC) 1 dedicated management
port. SIOC 1 is on the left side as you look at the server rear (see
Figure 1-2 on page 1-2 ).
Note Always use SIOC 1 for the management port connection, even if you have two SIOCs.
Step 3 Allow your preconfigured DHCP server to assign an IP address to the server node.
Step 4
Use the assigned IP address to access and log in to the Cisco IMC for the server node. Consult with your
DHCP server administrator to determine the IP address.
Note
The default user name for the server is admin . The default password is password .
Step 5
From the Cisco IMC Server Summary page, click Launch KVM Console . A separate KVM console
window opens.
Step 6 From the Cisco IMC Summary page, click Power Cycle Server . The system reboots.
Step 7
Select the KVM console window.
Note
The KVM console window must be the active window for the following keyboard actions to
work.
Step 8
When prompted, press F8 to enter the Cisco IMC Configuration Utility. This utility opens in the KVM
console window.
This utility has two windows that you can switch between by pressing F1 or F2.
Step 9
Continue with Cisco IMC Configuration Utility Setup, page 2-13 .