D15107.05
Codec SX80 API Reference Guide TC7.3, OCTOBER 2015.
Copyright © 2015 Cisco Systems, Inc. All rights reserved.
114
Cisco TelePresence SX80
API Reference Guide
Logging commands
xCommand Logging ExtendedLogging Start
Turns on the extended logging, which stores more information than regular logging in the log files.
You can determine the duration in seconds. Note that extended logging uses more of your video
system’s resources, and should only be used when troubleshooting an issue.
Requires user role:
USER
Parameters:
Duration: <1..600>
Example:
xCom mand Logging ExtendedLogging Start Duration: 20
xCommand Logging ExtendedLogging Stop
Stops the logging started with xCommand SystemUnit Diagnostics ExtendedLogging Start.
Requires user role:
USER
Example:
xCom mand Logging ExtendedLogging Stop
Message commands
xCommand Message Alert Clear
Remove the message which was displayed using the xCommand Message Alert Display command.
This is required when the Duration parameter is not set.
Requires user role:
ADMIN
Example:
xCom mand Message Alert Clear
xCommand Message Alert Display
Display a message on screen, for a specified duration of time (in seconds). NOTE: If Duration is not
set, the command must be followed by xCommand Message Alert Clear.
Use the xFeedback commands to monitor the feedback from the user. Read more about the xFeed-
back commands in the API introduction section in this guide.
Title: Enter a message title.
Text: Enter the message to be displayed. The <p> and <br> HTML tags will result in line breaks as
normal; any other tags will appear as plain text.
Duration: Set how long (in seconds) the message is to be displayed on the screen. If set to 0 (zero)
the message does not disappear until a xCommand Message Alert Clear message has been sent.
Requires user role:
ADMIN
Parameters:
Title: <S: 0, 255>
Text(r): <S: 0, 255>
Duration: <0..3600>
Example:
xCom mand Message Alert Display Title: "Message" Text: "The meeting will
end in 5 minutes." Duration: 20
Contents
Introduction
About the API
xConfiguration
Appendices
xCommand
xStatus
xCommand
