Cisco Small Business 300, Руководство администратора

Страница: 78 / 483

Administration: General Information
Console Settings (Autobaud Rate Support)
61 Cisco Small Business 300 Series Managed Switch Administration Guide
5
• Host Name —Select the host name of this device. This is used in the prompt
of CLI commands:
- Use Default —The default hostname (System Name) of these switches is:
switch123456 , where 123456 represents the last three bytes of the
device MAC address in hex format.
- User Defined —Enter the hostname. Use only letters, digits, and hyphens.
Host names cannot begin or end with a hyphen. No other symbols,
punctuation characters, or blank spaces are permitted (as specified in
RFC1033, 1034, 1035).
• System Mode —Select the system mode of this device.
NOTE
If you change the system mode after clicking Apply , the system will
require a reboot, and the startup configuration file will be gone after the boot.
- L2 —Select to place the device in Layer 2 system mode.
- L3 —Select to place the device in Layer 3 system mode.
• Custom Login Screen Settings —To display text on the Login page, enter
the text in the Login Banner text box. Click Preview to view the results.
NOTE
When you define a login banner from the web-based configuration
utility, it also activates the banner for the CLI interfaces (Console, Telnet, and
SSH).
STEP 3
Click Apply to save the values in the Running Configuration file.
Console Settings (Autobaud Rate Support)
The console port speed can be set to one of the following speeds: 4800, 9600,
19200, 38400, 57600, and 115200 or to Auto Detection.
Auto Detection enables the device to detect your console speed automatically, so
that you are not required to set it explicitly.
When Auto Detection is not enabled, the console port speed is automatically set to
the last speed that was set manually at (115,200 by default).
When Auto Detection is enabled but the console baud-rate was not yet
discovered, the system uses speed 115,200 for displaying text (for example, the
boot-up information).