Cisco Small Business 300, Руководство администратора

Страница: 479 / 483

SNMP
Notification Recipients
Cisco Small Business 300 Series Managed Switch Administration Guide 462
23
Defining SNMPv3 Notification Recipients
To define a recipient in SNMPv3:
STEP 1
Click SNMP > Notification Recipients SNMPv3 .
This page contains recipients for SNMPv3.
STEP 2
Click Add.
STEP 3
Enter the parameters.
• Server Definition —Select whether to specify the remote log server by IP
address or name.
• IP Version —Select either IPv4 or IPv6.
• IPv6 Address Type —Select the IPv6 address type (if IPv6 is used). The
options are:
- Link Local —The IPv6 address uniquely identifies hosts on a single
network link. A link local address has a prefix of FE80 , is not routable, and
can be used for communication only on the local network. Only one link
local address is supported. If a link local address exists on the interface,
this entry replaces the address in the configuration.
- Global —The IPv6 address is a global Unicast IPV6 type that is visible and
reachable from other networks.
• Link Local Interface —Select the link local interface (if IPv6 Address Type
Link Local is selected) from the pull-down list.
• Recipient IP Address/Name —Enter the IP address or server name of
where the traps are sent.
• UDP Port —Enter the UDP port used to for notifications on the recipient
device.
• Notification Type —Select whether to send traps or informs. If both are
required, two recipients must be created.
• Timeout—Enter the amount of time (seconds) the device waits before re-
sending informs/traps. Timeout: Range 1-300, default 15
• Retries—Enter the number of times that the device resends an inform
request. Retries: Range 1-255, default 3