![background image](http://html.mh-extra.com/html/cisco/fm1200-volo/fm1200-volo_installation-and-configuration-manual_67771113.webp)
IMPORTANT
The RADIUS feature is only available if the Cisco FM1200 Volo
is set to
Mesh Point
mode or
Mesh End
mode. If the unit is
set to
Bridge
mode, the
-radius
menu option will not be
available.
The RADIUS functionality will fail to operate if the network time
protocol (NTP) feature is not enabled and configured.
IMPORTANT
Use of this window requires extensive familiarity with the
RADIUS networking protocol. Do not change these settings
unless there is a specific need to do so.
To change the RADIUS settings for the Cisco unit, do the following
steps:
1.
Enable and configure network time protocol (NTP) as shown in
“NTP Configuration” (page 116)
.
2.
Click the
-radius
link under
ADVANCED SETTINGS
in the left-
hand settings menu.
• The
RADIUS
dialog will be shown (
).
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 113 of 175