![background image](http://html.mh-extra.com/html/cisco/fm1200-volo/fm1200-volo_installation-and-configuration-manual_67771055.webp)
Figure 20. RACER™ Cloud connection info status (Disconnected)
Configure the unit by doing the following steps:
1.
Click the
Reset to Provisioning
button at the bottom of the
DHCP fall-back configuration
section.
2.
Do a local (offline) configuration using the Configurator interface.
For further information, refer to
“Device configuration using the
configurator interface” (page 45)
.
For a quick overview of the initial configuration process, refer to the
flowchart below.
NOTE
Each individual Cisco radio transceiver unit has a factory-set
mesh identification number that takes the form
5.w.x.y
.
If the unit's IP address is set to
169.254.x.y/24
as in Case 2
below, the values
x
and
y
represent parts
x
and
y
of the unit's
mesh identification number.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 55 of 175