Figure 46. Configurator GUI (RADIUS dialog)
3.
Choose the RADIUS mode for the device by clicking the
RADIUS
Mode
drop-down and selecting one of the following options:
•
Disabled
: RADIUS functionality will be disabled.
•
Enabled
: RADIUS functionality will be enabled, and the
configuration options will be shown.
•
Passthrough
: If the device is a trackside-mounted Fluidity
device, this parameter can be used to simultaneously
activate RADIUS device authentication, and enable
RADIUS passthrough (communication between RADIUS-
authenticated
vehicle-mounted
devices
and
non-
authenticated trackside-mounted devices).
4.
Enter the IP address or host name of the RADIUS server in the
IP
address / hostname
field.
5.
By default, the RADIUS port number is
1812
. Do not change the
port number unless there is a specific need to do so.
6.
Enter the RADIUS access password in the
Secret
field. To read
the password as it is typed, check the
show
check-box.
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 114 of 175