Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device, Руководство по настройке

Страница: 361 / 432

C-169
Cisco 11000 Series Secure Content Accelerator Configuration Guide
78-13124-05
Appendix C Command Summary
Configuration Command Set
finwt2time
Specifies the amount of time to wait after acknowledgement of an initial FIN prior
to closing the TCP connection.
finwt2time <seconds|default>
no finwt2time
Syntax Description
Usage Guidelines
Availability: Serial, Telnet; FIPS Mode (serial only)
FIN-WAIT-2 is the state entered after the acknowledgement of an initial FIN. The
stack remains in this state until the retransmission queue is emptied, and the user’s
CLOSE can be acknowledged. Use the no form of the command to return the
finwt2time to the global value. If no global settings exist for a parameter, the
factory default parameter is used instead. See RFC 793.
keepalive
Specifies the amount of time to keep a TCP connection open without active traffic.
keepalive <seconds|default>
no keepalive
Syntax Description
seconds The number of seconds to wait after acknowledgement
of an initial FIN prior to closing the TCP connection;
the valid range is from 60 to 675 seconds (inclusive).
default The factory default. At the time of publication, the
factory default is 60 seconds.
seconds The number of seconds a to keep a TCP connection
open without active traffic; the valid range is from 0 to
65535 seconds (inclusive).
default The factory default. At the time of publication, the
factory default is 60 seconds.