Cisco CSS11501 - 100Mbps Ethernet Load Balancing Device, Руководство по настройке, Страница: 278 / 432

Appendix C Command Summary
Configuration Command Set
C-86
Cisco 11000 Series Secure Content Accelerator Configuration Guide
78-13124-05
Using the no form of the command removes the specified IP address from the
syslog list of the current device. Up to four IP addresses can be specified. Syslog
messages are sent to all hosts at the IP addresses in this list.
As part of authentication logging, all successful and failed authentication attempts
are now logged to syslog hosts and the system messages. Because two separate
passwords can be used for the device, log messages for the “access” and “enable”
passwords are differentiated as “Access Authentication” and “Enable
Authentication”, respectively. Authentication messages contain:
•
The type of management session (serial, telnet, or Web management)
•
The source IP address
• Authetication result of either “invalid” or “successful” for each action
Related Commands
show syslog (Non-Privileged Command Set)
telnet access-list
Assigns an existing access list to be used with telnet management requests.
telnet access-list <id>
no telnet access-list <id>
Syntax Description
Usage Guidelines
Availability: Serial, Telnet
Use the no form of the command to remove the specified access list. The access
list still exists but is no longer used by the telnet subsystem.
id The identifier corresponding to an access list
configured on the current device.