3-11
Cisco Wireless IP Phone 7920 Administration Guide for Cisco CallManager Release 4.0 and 4.1
OL-7104-01
Chapter 3 Setting Up Cisco Wireless IP Phones
Configuring IP Phones in Cisco CallManager
Related Topics
•
Support for the Cisco 7920 Phone Type, page 3-11
•
Adding Phones with Auto-Registration, page 3-8
•
Adding Phones with Auto-Registration and TAPS, page 3-9
•
Adding Phones with Cisco CallManager Administration, page 3-11
Adding Phones with Cisco CallManager Administration
You can add phones individually to the Cisco CallManager database using
Cisco CallManager Administration. To do so, you first must obtain the MAC
address for each phone. See the
“Adding Phones to the Cisco CallManager
Database” section on page 3-7
for instructions.
After you have collected MAC addresses, choose
Device > Add a New Device
in
Cisco CallManager Administration to begin.
For additional instructions and conceptual information about Cisco CallManager,
refer to
Cisco CallManager Administration Guide
and to
Cisco CallManager
System Guide
.
Related Topics
•
Support for the Cisco 7920 Phone Type, page 3-11
•
Adding Phones with Auto-Registration, page 3-8
•
Adding Phones with Auto-Registration and TAPS, page 3-9
•
Adding Phones with BAT, page 3-10
Support for the Cisco 7920 Phone Type
Cisco CallManager release 3.3(3) SR1 and later includes support for the
Cisco 7920 phone type in the Cisco CallManager Administration application.
(Previously, there was no phone type for this phone and you had to configure it as
a Cisco IP Phone 7960.)
If you upgrade to Cisco CallManager release 3.3(3) SR1 and later, you can choose
the Cisco 7920 phone type when adding the wireless phone. However, if you
perform the upgrade and have Cisco wireless phones on your network that were
Содержание 7920 - Unified Wireless IP Phone VoIP
Страница 4: ......
